Mallory-ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M

1MALLORY TECHNICAL SUPPORT (775) 882-6600 www.malloryracing.com

E-SPARK™ BREAKERLESS CONVERSION KIT

FOR MALLORY POINT DISTRIBUTORS

NOTE: This product is legal in California only for racing vehicles which may never be operated upon a highway.

INSTALLATION INSTRUCTIONS

FORM 1673 1/07

APPLICATIONS

Part No. 61010M For Left-Hand Rotation 27 Series

Mallory 8 cylinder point automotive

vacuum advance equipped

distributors which use a standard

stack cap (Part no. 209).

Part No. 61011M For Right-Hand Rotation 27

Series Mallory 8 cylinder point

automotive vacuum advance

equipped distributors which use a

standard stack cap (Part no. 209).

Refer to the Mallory Catalog’s distributor application section

if you need a to determine your distributor’s rotation.

PARTS INCLUDE IN THIS KIT:

1 E-Spark™ Plate Assembly

1 Wire Harness

1 Rotor/Shutter Wheel Assembly (PN 322)

1 Wire Connector

1 Grommet

1 Rubber Plug

1 Thrust Button

WARNING

You must install the E-Spark™ Conversion Kit

exactly as shown in these instructions. After the

kit is installed—and before you start the engine—

check all wiring again. Mis-wiring will cause the

E-Spark™ Ignition to fail immediately.

INSTALLATION

Step 1

Rotate the engine to the #1 cylinder firing position.

Remove the distributor cap and note the position of

the rotor. You will need to reference this when you

reinstall the distributor. Remove the distributor from

the engine.

Step 2

Remove the rotor, and then remove the condenser

and bracket. Remove the insulators (Figure 1).

IMPORTANT

All kits listed below must be used with an ignition ballast resistor (or loom resistance wire) to prevent

module failure. If your vehicle is not equipped with a ballast resistor or loom resistance wire, Mallory

Ballast Resistor (Part No. 700) or Mallory Coils 29219, 29450 or 30450 (which are internally ballasted)

may be used.

FIGURE 1

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

1MALLORY TECHNICAL SUPPORT (775) 882-6600 www.malloryracing.comE-SPARK™ BREAKERLESS CONVERSION KITFOR MALLORY POINT DISTRIBUTORSNOTE: This product is

Page 2 - Thrust Button

Step 3Remove the e-clip from the vacuum advance arm(Figure 2). Remove the 2 screws holding the vacuumadvance chamber from the outside of the distribut

Page 3 - With a paper

Step 6This step requires you to drill a 3/8” hole in the distributor housing to accommodate the new wiringharness. Measure 1” from the existing insula

Page 4 - Connector

MALLORY IGNITION 550 MALLORY WAY, CARSON CITY, NV 897014Step 10Insert the rubber plug into the existing grommet hole(Figure 12). This is a tight fit a

Page 5

5MALLORY TECHNICAL SUPPORT (775) 882-6600 www.malloryracing.comStep 12Install the connector onto the wires. Be sure the wiresare in the correct positi

Page 6 - FIGURE 17

MALLORY IGNITION 550 MALLORY WAY, CARSON CITY, NV 897016COIL–+EQUIPPED WITH LOOM RESISTANCE WIRE12V/IgnitionSwitchEngineGroundBrownGreenAll other wire

Page 7 - FIGURE 18

7MALLORY TECHNICAL SUPPORT (775) 882-6600 www.malloryracing.com7COIL–+12V/IgnitionSwitchEngineGroundBrownGreenAll other wires originally connectedto t

Page 8 - FOR MARINE USE ONLY

8 www.malloryracing.comMALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144216.688.8300 FAX 216.688.83

Commentaires sur ces manuels

Pas de commentaire

Mallory-ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_ Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Mallory-ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_. Mallory Ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_61011M User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Mallory-ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_ Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Mallory-ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_. Mallory Ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_61011M User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Mallory-ignition Mallory E-SPARK BREAKERLESS CONVERSION KIT 61010M_