Mallory-ignition Mallory Distributor Gear/Coupling Manuel d'utilisateur télécharger pdf

Distributor Gear/Coupling Instructions

Some Mallory distributors and magneto bases ar

e not

equipped with a drive gear or coupler. If your original

distributor is equipped with a drive gear or coupler and the

Mallory distributor is not, remove the gear or coupling from

the original distributor and install it on the Mallory

distributor. Follow the instructions listed below.

Step 1

Remove the gear or coupler from the OEM distributor by

pressing or punching out the roll pin.

NOTE: Remove and retain the thrust washer located just

above the gear/coupler.

Step 2

Grasp the Mallory distributor or magneto base at the hous-

ing and pull down on the shaft to remove all slack

(Figure 1).

Step 3

Install the OEM thrust washer and gear/coupler onto the

Mallory distributor or magneto by sliding them onto the

shaft. Push on the shaft from above while holding the thrust

washer and gear against the housing to remove all slack

(Figure 2).

Step 4

Pull the gear/coupler away from housing enough to insert a

.020” feeler gauge (Figur

e 3). After inserting feeler gauge,

press on both ends of distributor or magneto to remove all

slack.

Step 5

Using the hole in the OEM gear/coupler as a guide, drill a

hole through the Mallory shaft using a drill bit the exact size

of the hole in the OEM distributor shaft (Figure 4).

NOTE: Ensure that all slack is removed and feeler gauge

remains in place while drilling. We strongly recommend

using a drill press for this procedure.

Step 6

Press a new roll pin (the same size as the OEM pin) into

gear/coupler shaft. Remove the feeler gauge. The gear/cou-

pler should be pinned to the shaft and the gear should move

.010” to .030” relative to the housing.

FORM 854 04/05

INSTALLATION INSTRUCTIONS

1MALLOR

Y IGNITION

www

.malloryracing.com

FIGURE 1

FIGURE 2

PULL ON SHAFT TO

HOLD ONTO HOUSING

OEM THRUST WASHER

OEM GEAR OR COUPLER

HOLD ONTO GEAR

PUSH ON THE SHAFT

1 2

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

Distributor Gear/Coupling InstructionsSome Mallory distributors and magneto bases are notequipped with a drive gear or coupler. If your original distr

Page 2 - FIGURE 4

FORM 85404/05Made in U.S.A.Printed in U.S.A.MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144216.68

Commentaires sur ces manuels

Pas de commentaire

Mallory-ignition Mallory Distributor Gear/Coupling Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Mallory-ignition Mallory Distributor Gear/Coupling. Mallory Ignition Mallory Distributor Gear/Coupling User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Mallory-ignition Mallory Distributor Gear/Coupling