Mallory-ignition LAKEWOOD DRIVE SHAFT SAFETY LOOP 18005 Manuel d'utilisateur télécharger pdf

The Lakewood Drive Shaft Safety Loop is made from

1/4" thick steel and is 2" wide which complies with

specifications stated in the NHRA & IHRA rule books.

This safety loop is designed to fit near the transmission

tail shaft in the tunnel area.

WORK SAFELY!

Installation of this Drive Shaft Safety

Loop requires working inside and underneath the

vehicle USE EXTREME CARE AND CAUTION WHEN

WORKING UNDERNEATH ANY VEHICLE. Never get

near or under vehicle until you are confident that it is

safely supported and will not move or fall from its

raised position.

DO NOT USE A BUMPER JACK.

PREPARATION FOR INSTALLATION

1. Place vehicle on solid level surface such as a

garage floor to ensure safe installation.

2. Place wheel blocks or wedges in front of and

behind both rear wheels to prevent movement in

either direction.

3. Carefully place floor jack under front engine

cross member. Be careful not to damage rack

and pinion unit.

4. Raise front of vehicle up with floor jack and place

automotive approved support stands having

adequate load capacity under lower control arms.

5. Lower floor jack until control arms are resting

securely on the support stands.

CAUTION:

DO NOT BEGIN THIS INSTALLATION UNTIL

YOU ARE CONFIDENT THAT VEHICLE IS SECURE AND

SAFELY SUPPORTED.

DRIVE SHAFT SAFETY LOOP INSTALLATION

1. Assemble the safety loop “loosely” around Drive

Shaft, about 6-8 inches away from the Transmission

Tail shaft. (See Figure A)

2. Next, remove the lightweight aluminum heat shields

for installation. (Please note, these can be

re-attached after loop installation, if needed.)

3. Next, position the outer loop frame brackets, on both

sides, around the frame rail sections where the loop

will be mounted. (See Figure B)

4. Then, finger tight all nuts and bolts stiffening up the

assembly so you can test mount the safety loop prior

to permanent installation.

5. Once you have tested where the loop needs to be

mounted, make sure you have proper clearance

around drive shaft and exhaust. (See Figure A)

6. Now that the safety loop is in the desired location,

mark the bracket holes on the frame and then drill

holes with 3/8” drill bit for attaching the outer frame

brackets. (See Figure B)

7. Next, install bolts through frame mounting brackets

and through the drilled frame holes mounting the

safety loop in place.

LAKEWOOD DRIVE SHAFT SAFETY LOOP

#18005

INSTALLATION INSTRUCTIONS

Fits: 2005-2006 FORD MUSTANGS

Lakewood Industries is a Mr. Gasket Performance Group Company.

Figure A

Figure B

Nuts go

on outside

After

positioning

mark and drill

1 2

Résumé du contenu

Page 1 - Fits: 2005-2006 FORD MUSTANGS

The Lakewood Drive Shaft Safety Loop is made from 1/4" thick steel and is 2" wide which complies with specifications stated in the NHRA &

Page 2 - TECHNICAL SERVICE

8. For correct placement of the drive shaft safety loop. (See Figure C)9. Be sure to tighten and torque down all fasteners after correct installation

Commentaires sur ces manuels

Pas de commentaire

Mallory-ignition LAKEWOOD DRIVE SHAFT SAFETY LOOP 18005 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Mallory-ignition LAKEWOOD DRIVE SHAFT SAFETY LOOP 18005. Mallory Ignition LAKEWOOD DRIVE SHAFT SAFETY LOOP 18005 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Mallory-ignition LAKEWOOD DRIVE SHAFT SAFETY LOOP 18005